Sunday January 30, 2005Over this weekend I was able to finish the clean-up and painting of the exhaust manifold. It came out real nice but I will be sending it out to be ground square. It appears to be warped. The #1 exhaust area is not fitting flat against the engine block. Actually when I first took the motor apart the bottom stud on the #1 exhaust port was already broken off. Thanks to the help of the P15D24 website I was able to get my distributor wiring in correct. New points, capacitor, rotor, cap, vacuum advance module, sparkplug wires, and coil. Getting closer to run day... |
|