Hello,
What does the rear oiler on a factory 1930 30U water pump look like? According the the owner's manual, the water pump should have an open oil hole at the front an a oil cup on the rear. Is it a small spring-door cup, does it have a bend or angle to it? Is it a larger cup? Not sure. My car had a 4" long tube screwed in with a zerk fitting for grease at the end. The hole is not vertical, it comes out at maybe a 15-20 degree angle, so thought I'd ask the experts what is correct for the car. Thanks!
-Chris
There were couple different pumps in 30's do you have pic . Mine is oil front bushing and grease rear were holds water back and packing rope on shaft . Mine is on '31 Truck with PA engine .
See attached photo
Not exactly like mine but similar . Would say marine grease in rear .
Thank you kindly for the response, but I need to know what the original oil cup looked like. It originally had an oil cup, not a grease fitting. Any other owners have a response? Thanks again.
Here some pics of friends . Is about 5/16" opening . Looks like grease in .
(//)
Retry,
(//)
(//)
Thank you for the photos. This is what I was looking for; I appreciate it.
-Chris