28Q29U Plymouth Forum

General Category => General Discussion => Topic started by: Articifer Tom on July 06, 2018, 11:47:52 PM

Title: Info needed on brake line
Post by: Articifer Tom on July 06, 2018, 11:47:52 PM
Looking for info to make a brake reservoir to master tube . Mine was PO changed to braided hose . First is it 1/4 or 5/16 od copper and total length . And if you know nut size and thread . Thanks .   
Title: Re: Info needed on brake line
Post by: chetbrz on July 07, 2018, 07:23:00 PM
Tom,

The line from reservoir to master cyl is 5/16" copper tubing with flare connectors.  45 degree flare

You can purchase from Grainger or a good industrial supply company. 

See Link:  ( Click for Long Nuts for proper fittings)  Used on old hydraulics and modern pneumatics.

https://www.grainger.com/category/flared-tube-fittings/tube-fittings/pipe-tubing-and-fittings/plumbing/ecatalog/N-qw3 (https://www.grainger.com/category/flared-tube-fittings/tube-fittings/pipe-tubing-and-fittings/plumbing/ecatalog/N-qw3)
Title: Re: Info needed on brake line
Post by: Articifer Tom on July 08, 2018, 12:47:44 PM
Thanks Again Chet .