Recent Posts

Pages: [1] 2 3 ... 10
1
General Discussion / Re: engine bay splash pans....
« Last post by Articifer Tom on Today at 03:18:39 AM »
Received mine in mail today . Thanks again . will post finish product , maybe awhile been busy baby sitting for 3 more weeks as daughter recovers from second grand daughters birth . also weather been terrible for me .
2
General Discussion / Re: Sill or Chassis rail dimensions 1929 Plymouth U
« Last post by chetbrz on January 17, 2018, 02:30:03 AM »
Thanks Geoff,

I could have used this info 9 months ago but better late than never.  I will move these documents into the Tech Area if you don't mind.

Chet...
3
General Discussion / Re: engine bay splash pans....
« Last post by kimmc on January 16, 2018, 01:23:13 AM »
Hey Chet.  Thanks for taking the time to do this.  I think I can manage the fabrication from your very complete drawing.  Best, Kim Mc
4
General Discussion / Re: engine bay splash pans....
« Last post by chetbrz on January 15, 2018, 07:22:14 PM »
Kim & Tom,

I traced the front pan support.  The pictures below illustrate how I traced it.  The flat length of the material would be 17" long 16 gauge steel by 4.5"wide (actual measured 4 7/16" wide)

If you want I can make copies of the 8.5 x 14 document and send it to you.  Just email me your address.







If you can print an 8.5 X 14" document download the attached pdf file
5
General Discussion / Sill or Chassis rail dimensions 1929 Plymouth U
« Last post by Geoff57 on January 15, 2018, 05:42:59 AM »
I extrapolated the mirror image dimensions for the sills from four rotten sills which between them were 90% measurable
6
General Discussion / S11V Ignition points 1929 Plymouth U
« Last post by Geoff57 on January 15, 2018, 05:35:31 AM »
No ignition points were with the distrbutor (dizzy) when I picked up the Plymouth. The car was all pulled apart including the dizzy. The S11V points for some Australian Ford & GM cars late 60's to early 80's fit perfect. Just unclick the points arm contact from the housing
7
General Discussion / Re: Windshield wipper assy.
« Last post by 29UJohn on January 15, 2018, 02:45:28 AM »
There is an excellent article on Trico wiper vacuum motors in the January 2017 issue of Skinned Knuckles.
8
Things you are looking for. / Re: 29U hex style hubcap - wanted for reproduction
« Last post by 29UJohn on January 15, 2018, 02:42:36 AM »
Yes, I did receive two good ones.  I hope to have some Reproductions by this summer.  I need to take down this request.
Thanks.
John
9
Things you are looking for. / Re: 29U hex style hubcap - wanted for reproduction
« Last post by kimmc on January 15, 2018, 02:21:52 AM »
John:  Did you ever get a good cap?  If not, I will look through my collection; I may have one that might be acceptable to you.  Let me know at kimmc@softcom.net    Kim  Mc
10
General Discussion / Re: Radiator Emblem
« Last post by 29UJohn on January 13, 2018, 04:54:23 PM »
Chet, Thanks -  I'll have to save those instructions!
Pages: [1] 2 3 ... 10