• Welcome to 28Q29U Plymouth Forum.
 

News:

NEW FORUM version is here. 
If you are experiencing any problems, contact chetbrz@aol.com
WELCOME Auto Registration is turned OFF. 
In order to register for this forum please contact chetbrz@aol.com to request access.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - frankp

#16
General Discussion / Re: Hey Fellas
April 17, 2021, 01:07:19 PM
Nice!  Great find Ted.  I'm ready for summer!    frank
#17
General Discussion / Re: Manufacturers plate
April 15, 2021, 12:16:00 AM
Great progress!  Look forward to your completion.     frank
#18
General Discussion / Re: Oil pump check valve
February 04, 2021, 09:23:48 PM
Russ, you should be good to go then, if soldering is good when corks replaced. Other folks have had problem with valve seat at inner tank.  I've never experienced and can't describe any symptoms.  I also sealed the inside of outer tank as it was starting to weep around the bottom.

Look forward to hearing about your success.  frank
#19
General Discussion / Re: Oil pump check valve
February 04, 2021, 04:53:53 PM
Russ,
If the corks are secured on the brass shaft, there shouldn't be a problem.  Of course, if a check valve works, it would be a preventive measure and provide peace of mind.  As they say, your oil gauge is your friend.  If the oil is diluted with gas, the pressure drops.  That's how I knew I had a problem.  One whiff of the dipstick told me what it was.   frank
#20
General Discussion / Re: Oil pump check valve
February 04, 2021, 12:27:31 PM
To my knowledge, there is no check valve in the system.  It happened to me when the Kingston malfunctioned, but it has been very reliable.   frank
#21
General Discussion / Re: Happy Holidays
December 27, 2020, 06:59:24 PM
Older and slower, missed Christmas.  Safe and Happy New Year to everyone!  frank
#22
Well done, Chet!
#23
General Discussion / Re: Happy Thanksgiving
November 26, 2020, 04:57:53 PM
Thanks Chet, Tom.  Happy and safe Thanksgiving to everyone.
#24
Congratulations on job well done!!  Far cry from your "red" original!
#25
Tom,  I just followed the instructions in the manual to adjust slop.  Too far back to remember any details for guidance worth a hoot.  Have all your gears gone kaput?
#26
Tom,  I see the Steering gear worm Q,U,30-U as 42834.  I sure don't see a listing for a tooth gear though.
#27
General Discussion / Re: 1929 Plymouth ignition key
August 27, 2020, 01:11:11 PM
Like Tom, a local locksmith made a key from the IM number.  The blank was not an original though.
#28
General Discussion / Re: 29 Build Thread - Part 3
August 27, 2020, 01:01:22 PM
Chet, You and your wife doing great work!  Now for the hat.
#29
General Discussion / Re: 29 Build Thread - Part 3
July 30, 2020, 12:57:44 AM
Won't be long now!
#30
General Discussion / Re: 29 Sedan Foot Rest
July 19, 2020, 03:13:12 PM
Chet, the total length from end piece to end piece is 33.5"  I don't know how much of the tube is actually in each end, maybe 3/4"