LOL is anything straight forward with these cars ?
NEW FORUM version is here.
If you are experiencing any problems, contact chetbrz@aol.com
WELCOME Auto Registration is turned OFF.
In order to register for this forum please contact chetbrz@aol.com to request access.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: 29UJohn on January 30, 2017, 09:09:22 PM
Chet,
Mortising in the sill covers into the floor so they are flush would seem to allow the sill plates to sit flat. It seems like it would be better, and I have wondered about this. But I do not think this was the case for my original floor boards, as I did not see any indication that they were mortised in. But that was 43 years ago!
Quote from: 29UJohn on January 29, 2017, 06:54:15 PM
If you need information on the curve of the sill wood, i have a new set of sill plates. The outer edge of the sill plates approximates the outer edge and curve of the outer wood edges. If that would help, I could trace the sill plate edges and send to you.
Quote from: jeffrey grare on January 25, 2017, 06:31:56 PM
Chet, just checked ebay its listed under Tips on auto body woodwork by Don Marsh $18.00 JG
Quote from: 29UJohn on January 21, 2017, 09:31:53 PM
That has been a mystery to me. All I know is the vague picture in the instruction handbook.