Well, I checked the timing and the rotor was pointed where it was supposed to be. I static timed again and rotor was correct, so I believe the timing did not shift. The car is wanting to start, will run rough for a few seconds, but looks like it's flooding out.
I'm going to disassemble the carb and check to see if the float has a hole in it and clean everything up. I had to repair it about 12 years ago.
Does anyone know where I can get a rebuild kit? I can get the same basic kit I used back then for about $30. Any other ideas?
I'm going to disassemble the carb and check to see if the float has a hole in it and clean everything up. I had to repair it about 12 years ago.
Does anyone know where I can get a rebuild kit? I can get the same basic kit I used back then for about $30. Any other ideas?