28Q29U Plymouth Forum

General Category => General Discussion => Topic started by: jjohn on August 10, 2023, 11:37:47 AM

Title: Fender list to 2 door sedan 1929
Post by: jjohn on August 10, 2023, 11:37:47 AM
I'm wondering what size/type of fender welting I shall use for the 1929 2-door Sedan.
I found one supplier: https://www.steelerubber.com/ ok?

1. Is it a list between front fender and frame? (see image)
2. Is it a list between running board and frame (see image)


Title: Re: Fender list to 2 door sedan 1929
Post by: chetbrz on August 10, 2023, 03:27:51 PM
I'll see what I can answer.

The Front.

The joint you circled in the picture is supposed to be just that, no visible fender welt.

The Running board is supposed to have stainless steel outer Trim. See picture.
Running Board.jpg

The Rear fender I used either 1/4" or 5/16" black vinal welting.  Currently don't remember which one.
Title: Re: Fender list to 2 door sedan 1929
Post by: Russ T. Fender on August 10, 2023, 03:32:52 PM
Steel products are good quality and they usually fit properly unlike a lot of repro stuff.  They are pricey but worth it.   I bought a number of things from them for my 30-U coupe and was very satisfied.
Title: Re: Fender list to 2 door sedan 1929
Post by: jjohn on August 11, 2023, 06:05:27 AM
Thanks for the information,

So there is no rubber between the running board frame and the main frame?
Title: Re: Fender list to 2 door sedan 1929
Post by: Russ T. Fender on August 11, 2023, 08:59:01 AM
No welting there on my 30-U.
Title: Re: Fender list to 2 door sedan 1929
Post by: chetbrz on August 11, 2023, 09:29:54 AM
On my car there wasn't any visible welting between the running board and the kick panel.  I have only owned the car for 17 out of the 94 years this car has been around.  The reason I say visible welting is that in some areas, where metal meets metal, there was visible signs of a thin fibrous material used in the joining.  But not visible after the joining.
 
This is my 2 cents so I hope others will share their experiences.     
Title: Re: Fender list to 2 door sedan 1929
Post by: jjohn on August 11, 2023, 01:08:38 PM
Thank you
I will add a thin nitrile rubber sheet between the parts.
Title: Re: Fender list to 2 door sedan 1929
Post by: Touring29 on August 11, 2023, 08:41:40 PM
Camper top seal is good for places where you want a thin seal that won't stick to both sides. Tri-Five people often use it between the flippers and the roof on hardtops. It makes parts adjustment a lot easier than something sticky on both sides.
Title: Re: Fender list to 2 door sedan 1929
Post by: jjohn on August 12, 2023, 02:31:30 AM
is the Self Adhesive Camper Mount Foam Tape -same as the Camper top seal?
Title: Re: Fender list to 2 door sedan 1929
Post by: Articifer Tom on August 12, 2023, 10:05:56 AM
I believe the parts book calls for liner between running boards and splash panels and welt on end s . Definition of each I do not know . But personal use gaffers tape for liner . I is thin similar to duct tape . sticks one side .
Title: Re: Fender list to 2 door sedan 1929
Post by: Touring29 on August 13, 2023, 10:30:09 PM
Quote from: jjohn on August 12, 2023, 02:31:30 AMis the Self Adhesive Camper Mount Foam Tape -same as the Camper top seal?
Same thing as far as I know.