Print Page - '29 Plymouth Rear Wheel Puller Question

Title: '29 Plymouth Rear Wheel Puller Question
Post by: racertb on November 03, 2011, 02:24:50 PM

All:

I ordered my Model TT wheel puller from Snyder's and it fits perfectly on the threads so I can get off the rear wheels...the probelm is, the bolt that is to be tightened against the axle is too short! Has anyone else had this issue?

I assume I'll have to make a trip to Home Depot to get a longer bolt to make this work...

Ted

Title: Re: '29 Plymouth Rear Wheel Puller Question
Post by: Tinkeys on November 03, 2011, 05:45:15 PM

Try see if you can fit a spacer between end of bolt and axle ! Just needs to move less than half a mm and wheel will come off!
It is important to have puller screwed all the way in !!
Cheers Tony.

Title: Re: '29 Plymouth Rear Wheel Puller Question
Post by: racertb on November 03, 2011, 06:40:51 PM

Thanks Tony, I'll try that. The bolt is all the way in at the moment, but I'll see if I can make something work.

Title: Re: '29 Plymouth Rear Wheel Puller Question
Post by: Gary 30U on November 06, 2011, 01:08:46 PM

Yes, the bolt that comes with the TT puller was to short to work on my Plymouth. I just replaced it with one that i had in my parts stuff. You can go to the hardware store and get a replacement whatever length you want.

Gary

28Q29U Plymouth Forum

General Category => General Discussion => Topic started by: racertb on November 03, 2011, 02:24:50 PM