• Welcome to 28Q29U Plymouth Forum.
 

News:

NEW FORUM version is here. 
If you are experiencing any problems, contact chetbrz@aol.com
WELCOME Auto Registration is turned OFF. 
In order to register for this forum please contact chetbrz@aol.com to request access.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - sunnen1250

#1
General Discussion / Re: Does Anyone know...
December 27, 2017, 12:30:33 AM
You need to remove the clutch release fork in order to remove the clutch cover and disk.  You then must remove the flywheel. You must support the engine block and remove the rear engine mount bolts and the fasteners holding the flywheel housing to the engine block.  With the block supported you may then remove the flywheel housing.
#2
General Discussion / Re: Damaged flywheel on 1929 "U"
December 26, 2017, 07:00:17 PM
Thanks, I think the one on ebay may just work. 
#3
General Discussion / Damaged flywheel on 1929 "U"
December 26, 2017, 12:50:41 PM
Is there anyone who has had a 29 flywheel repaired.  The ring gear is badly damaged and needs to be repaired.  Does anyone know where I might find a ring gear or have one made that could be installed on the flywheel.  There is no replaceable ring gear on the 29 flywheel.  The gear is cut in the perimeter of the flywheel and the flywheel would have to be machined to accept a later model ring gear.  Any help will be greatly appreciated.