Author Topic: 1929 u sedan body to frame welt (webbing)  (Read 603 times)

jeffrey grare

  • Full Member
  • *****
  • Posts: 16
    • View Profile
1929 u sedan body to frame welt (webbing)
« on: February 06, 2016, 06:22:43 PM »
Is it possible there is only welting material at the mounting points? I see someone on ebay selling 1 1/2 x 2 x1/4" rubber pads with about a 1/2" hole in center. This seems to make sense as there was no residue other than rust on the underside of splash aprons or on the top of the frame rail. Also the sills would clear the rivet heads by about a 1/16" of an inch, and not collect any moisture as there would be a small gap under the sill.   Any input would be appreciated thank you    J.Grare 

imoore

  • Senior Forum Member
  • ****
  • Posts: 220
    • View Profile
Re: 1929 u sedan body to frame welt (webbing)
« Reply #1 on: February 07, 2016, 03:14:48 AM »
My holden bodies tourer is mounted on a series of rubber blocks. At each mount bolt.
1928 Q tourer (Holden bodied)
Several vintage stationary engine