Author Topic: 1929 u sedan crossmember  (Read 767 times)

jeffrey grare

  • Full Member
  • *****
  • Posts: 16
    • View Profile
1929 u sedan crossmember
« on: February 10, 2016, 06:14:58 PM »
One more question (hopefully my last for a while) Is there a cross member (wooden) where the front floorboard meets the angled floorboard (cowl) I cannot tell if the sills were mortised out as there was not much left of the front half of the sills. There was just some 1 x 6 pine screwed to the brackets in the cowl and a piece of plywood  laying on the floor. I would think it wouldn't have to be very big, just enough to keep floor from sagging. Again any input is appreciated thank you      J.Grare

frankp

  • POC MEMBER
  • Senior Forum Member
  • ****
  • Posts: 400
  • 29U 4dr Sedan #Y089WE
    • View Profile
Re: 1929 u sedan crossmember
« Reply #1 on: February 11, 2016, 03:40:17 PM »
There is no cross member in my sedan.  It had no original floor board.  The toe board was intact and appeared to be original.

Please feel free to ask questions.  I believe that's the reason Chet established this in the first place - share knowledge and assist where we can.

frank
frank p

chetbrz

  • POC MEMBER
  • Senior Forum Member
  • ****
  • Posts: 1215
    • View Profile
    • My Space on the Web
Re: 1929 u sedan crossmember
« Reply #2 on: February 11, 2016, 08:15:29 PM »

Please feel free to ask questions.  I believe that's the reason Chet established this in the first place - share knowledge and assist where we can.

frank

Frank, you are absolutely correct. !!!
http://www.1948Plymouth.info           Web Master - Forum Administrator - AACA member