Print Page - Horn Bracket Question for 29U

Title: Horn Bracket Question for 29U
Post by: 29UJohn on April 05, 2009, 11:22:52 PM

The horn mounting bracket broke off my 29U's engine head. I want to have a new one made. I am not sure the one I had was original. Can someone send me a closeup picture of a 29U engine that shows the horn bracket?

Should the horn be above the top of the cylinder head and off to the side? ???

Title: Re: Horn Bracket Question for 29U
Post by: 29plycoop on April 05, 2009, 11:32:58 PM

HI JOHN- My '29 Ply Coupe has what I believe to be an original horn mounting bracket. It is bolted up wit the two bolts that hold the cast iron water outlet to the left side of the block. From the water outlet bolts it makes a 90 deg. bend and mounts with two of the small screws that hold the round part of the horn together. Will try to get a photo tomorrow.

Title: Re: Horn Bracket Question for 29U
Post by: chetbrz on April 06, 2009, 08:21:10 AM

Mine is the same as the one Rich described.

Title: Re: Horn Bracket Question for 29U
Post by: 29plycoop on April 06, 2009, 03:21:29 PM

Here is the '29 Ply horn mounting bracket on my coupe. Hope this helps. - Rich

Title: Re: Horn Bracket Question for 29U
Post by: 29plycoop on April 06, 2009, 03:23:12 PM

2ed Photo '29 Ply horn bracket.

Title: Re: Horn Bracket Question for 29U
Post by: 29UJohn on April 07, 2009, 10:39:49 PM

Thanks guys - this helps a lot!

Now to get one fabricated :P...

28Q29U Plymouth Forum

General Category => General Discussion => Topic started by: 29UJohn on April 05, 2009, 11:22:52 PM