The yoke inside the wiper motor was broken (I think it is made of bakelite) so I did a 3D print of the material, The wiper motor ran very well after this replacement.
Does anyone have a problem with this part?

Hello
I started the motor and saw that the propeller shaft was wobbling a bit. See attached movie.
Is there some marking on the shaft and parts for centering the shaft I have missed?

Starting up the engine for the first time.
Full choke and 2 turns and the motor starts up. Oil pressure over 4.
When I close the choke to 50 % it still runs and I can increase the speed.

But when I try to close the choke the motor stops and will not idle.  Can it depend on e.g. air leakage? 

Do you have some good tips to clean the brass and tank without destroying the brass or soldering or the zinc too much?
The brass float is broken with several broken parts as shown in the image
I think I can repair it with soldering.

I'm wondering what size/type of fender welting I shall use for the 1929 2-door Sedan.
I found one supplier: https://www.steelerubber.com/ ok?

1. Is it a list between front fender and frame? (see image)
2. Is it a list between running board and frame (see image)

Hello

The brass cup is not so good maybe I can make it straight so the screw can seal properly- and I wonder if it's possible to buy it somewhere or a complete carburetor for 1929.

Carburetor for 1929 Carter needed
I have original one but the brass cup is very bad and the accerelaton adjustment screentrycken is missing.

When I started the motor I notice there is lot of heat in the carburetor intake part, see image red circle.
Is that normal?
I was think if the gasket between the metal and exhaust should work like an isolator to minimize the heat?
Or maybe some other problems ?

Hi
The small hole beside the acceleration assembly has no threading just a simple hole.
Shall it be some plug there (or screw)?

Where can I buy the leather sealing for the acceleration pump? (thecarburetorshop.com ?)

Hi
Does anyone know where this nut fits?
thanks,

Hi
The Hood that i have have 3 sections of ventilations but
if I look at other cars they have only one section of ventilations.
Does any have 3 sections? The car is from early 1929.

I wonder if any have a picture how the original running boards looks like.

I have these mounted on the car think they are newly manufactured late 50's

Hi
What are the reason of the fabrics and padding between the wood frame and steel body
Can I replace it with something else?

Is there anybody who has a radiator to sell or were to buy to 1929U 2 door sedan?
The radiator that was mounted was from 1930 and I think it will not fit to the body frame.
Is it the same radiator to 4 door/2 door / roadster /etc

Does anyone know suppliers of the sealing at the bottom for the windshield?
The original was very stiff..

I found this number (1685) on the wooden part under the front seats.
Is it a part number or does it some other meanings?

Is this the same vacuum tank from Chevrolet 1928 as in the Plymoyth 1929?

Hi,
Is there any metal lock/function to keep the battery in place in the box ( 2 door 1929U)

Hi
How much should the difference be rear and front of the wheel?
I read in the Chevrolet manual and they says 0 to 1/8"  taken from the metal rim.
If I take the distance in the center of the wheel (rear and front) and the rod have the shortest length I got 1"

Hi
Does anyone have any picture how the radiator is attached to the frame?
The hole in the frame looks strange..
The radiator that was with the car has a PA number.
Does this radiator fit to this car?
Thanks,