Thanks Ian. The copper gasket from the exhaust manifold to the block is not the issue (although I could replace if I replace the other). Need to replace the gasket between the intake and exhaust manifolds. This is where it blew out bad and shown in another thread. The gap is huge, about 1/8" to 3/16" so will have to double or triple up as it was in the past before I first tried to fix. I have another intake that I put in place and still the same gap, even when I tightened down.
While I have this apart and until I get some gaskets or gasket material, going to take apart the carb to clean and rebuild with the kit and float I have.
While I have this apart and until I get some gaskets or gasket material, going to take apart the carb to clean and rebuild with the kit and float I have.