I have sent you a pm

The brass bowl has been repaired several times so it is in bad shape.
I shall try to 3D-print a prototype in ABS material. Maybe it not can stand the heat from the motor.

Sorry, but what do you mean it have "different jets" ?

Hello

The brass cup is not so good maybe I can make it straight so the screw can seal properly- and I wonder if it's possible to buy it somewhere or a complete carburetor for 1929.

Hello
Is the Hood side still left?

Thanks for good info

Ok thanks
I can see a very thin crack maybe a half inch going to one of the vacuum port. Maybe drill a small hole to stop and use JB-Weld to repair?

Carburetor for 1929 Carter needed
I have original one but the brass cup is very bad and the accerelaton adjustment screentrycken is missing.

When I started the motor I notice there is lot of heat in the carburetor intake part, see image red circle.
Is that normal?
I was think if the gasket between the metal and exhaust should work like an isolator to minimize the heat?
Or maybe some other problems ?

 I don't know if this is useful is is from1928 Chrysler

Ok thanks and for the sketch - I will look more carefully 

Hi
The small hole beside the acceleration assembly has no threading just a simple hole.
Shall it be some plug there (or screw)?

Where can I buy the leather sealing for the acceleration pump? (thecarburetorshop.com ?)

Merry Christmas and Happy Holidays to you all

No, I just put the nut there for the picture..
thanks for the help

Hi
Does anyone know where this nut fits?
thanks,

Thanks for the pictures yes it looks like a de Soto
The hood fits very well against the body
Maybe they use the same manufacture that time.
If someone has any in the garage..