28Q29U Plymouth Forum

General Category => General Discussion => Topic started by: 1929luv on March 04, 2010, 10:22:26 PM

Title: 4Dr sill plates
Post by: 1929luv on March 04, 2010, 10:22:26 PM
My sill plates for the '29 4dr are real bad shape and have tried to use some ford ones and they are all to short does any one have any ideas were to get some or have some one that makes them thanks Craig
Title: Re: 4Dr sill plates
Post by: chetbrz on March 05, 2010, 07:15:19 AM
Craig,

If you are talking about the metal window trim pieces, they popup on ePay every now and again.  Body parts are generally a hard find.

Chet...
Title: Re: 4Dr sill plates
Post by: 1929luv on March 05, 2010, 11:31:09 PM
i am refering to the door sills at carpet or floor mat at edge of door at bottom, the aluminum pieces thanks Craig
Title: Re: 4Dr sill plates
Post by: Gary 30U on March 27, 2010, 02:37:15 AM
A bit of a wait, but try Door Sills (Don Kuhn) 81 Graham Ave., North Haledon, NJ 07508. Ph# 973-904-0270.

I sent him my old one from a 30U Coupe and he reproduced them out of aluminum, sorry no stainless. He was a fair wait time but well worth it in my opinion.

Gary
Title: Re: 4Dr sill plates
Post by: 1929luv on March 30, 2010, 08:55:16 PM
Thanks Gary

  I bill be sending mine to him so he can make thanks Craig
Title: Re: 4Dr sill plates
Post by: 1929luv on April 16, 2010, 10:57:49 PM
I got my sills in today and they are great!! I would recomend DON to any one thanks for the Input!!!!!! Thanks Craig
Title: Re: 4Dr sill plates
Post by: chetbrz on April 17, 2010, 04:05:04 PM
Could you post a picture once you get them installed.

Tks Chet...
Title: Re: 4Dr sill plates
Post by: Gary 30U on April 22, 2010, 11:37:00 PM
Chet, and any other interested parties. Here are the pics of the ones Don made for my 30U Coupe. I sent him my old ones and they made copies out of aluminum. Great detail, note the offset at the rear of the door. Fits perfectly.
Title: Re: 4Dr sill plates
Post by: Gary 30U on April 22, 2010, 11:38:45 PM
Just a full lenght view. Couldn't get both pics in one post.
Title: Re: 4Dr sill plates
Post by: chetbrz on April 23, 2010, 08:58:41 AM

Thanks Gary.., they look great.

Chet...