• Welcome to 28Q29U Plymouth Forum.
 

News:

NEW FORUM version is here. 
If you are experiencing any problems, contact chetbrz@aol.com
WELCOME Auto Registration is turned OFF. 
In order to register for this forum please contact chetbrz@aol.com to request access.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Articifer Tom

#1
General Discussion / Re: Propeller shaft 1929
February 19, 2024, 11:35:33 AM
Looks to be mounted off center only . Try loosing and use static pointer to set and center .My have to move on drum . to get closer center .
#2
General Discussion / Re: Happy Holidays!
December 31, 2023, 08:02:15 PM
In Mopars it seems to be RT was used to 1929 and after DRT were used with there slight overall frame larger size . Rt-08 model 121 to DRT-08 model 228 seems range of numbers .
#3
General Discussion / Re: Happy Holidays!
December 31, 2023, 10:26:28 AM
Yes to all . And Happy New Year too . My engine that I replaced rod in worked good all year . Found a Nice DRT Carter and refurbed it this month  . Time to install and test .
#4
Looks great .  Top down in December is rare . Enjoy !
#5
General Discussion / Re: Happy Thanksgiving
November 22, 2023, 09:34:17 AM
Happy back to yea'all .Missing driving weather .
#6
General Discussion / Re: Throttle lever question.
August 25, 2023, 12:18:34 PM
The way mine works you can clamp the rod in any position to have off or full on . In only moves from about 10 t0 12 o'clock for throttle range .
#7
General Discussion / Re: Engine not idling
August 21, 2023, 08:18:10 PM
Vacuum leak I would think make for hard starting if at all  . I wonder if if carb idle tube was changed . There are three critical orifices on that tube alone, that control until accel. is brought it to circuit .
#8
General Discussion / Re: Engine not idling
August 21, 2023, 03:02:09 PM
Use a light or VOM meter to set point as you turn to break . Easier and more accurate then looking .
  When has it worked correctly ? Did it start after rebuild or carb parts ?
#9
I believe the parts book calls for liner between running boards and splash panels and welt on end s . Definition of each I do not know . But personal use gaffers tape for liner . I is thin similar to duct tape . sticks one side .
#10
General Discussion / Re: I made a lever!
August 03, 2023, 07:57:58 PM
I used Q Bond glue system by KTool . It has black and white reinforcing powders and fast super glues . Did couple years ago on cracked steering wheel hub . Check You tubes on two thumbs up for me .
#11
General Discussion / Re: I made a lever!
July 29, 2023, 09:24:30 AM
Well Done . An artist .
#12
General Discussion / Tryon Front shackles On Ebay
June 26, 2023, 04:00:09 PM
Anyone needs oem new T705 shackles .At $50 now .
#13
I believe CRB-481 bolts with CRN-453 nuts match .Cross also to 58-68 Ford (352)+(390)engine bolts . Finding and price is another story .
#14
Can you post pic and length . i have spare rod bolts from my lasted endeavor on a 31 PA engine .Would probability use cotters instead of wire .
#15
Sorry mine 311 later series .