Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Rodney

Pages: [1]
1
General Discussion / Compression test
« on: August 15, 2009, 04:39:42 AM »
Hi all,

Iíve just preformed a cylinders compression test dry & wet. Does anyone know what the manufactures pressure should be? All my measurements for the four are between 50-60 psi.

Many thanks
Rodney

2
General Discussion / Tasmanian Trip
« on: July 30, 2009, 10:14:45 PM »
Hi everyone,

Well Iím finally returned from a successful 16 day club rally which took the Plymouth through some beautiful parts of Tasmania, Australia. All up it was a total of 1900 miles or 3057 kms.

The journey was very comfortable and we only had a few problems. A flat tire, some kind of fuel blockage which cleared it self after about 5 miles and an overcharging generator which upset the starter motor, not bad for an 80 year old vintage car!

We traveled with six other vintage cars of all different makes and models mine was the only Plymouth. I was using a lot of oil due to a rear bearing seal. The oil wasnít coming out from my exhaust but it was dripping out from the bell housing when I stopped. As long as I kept toping it up and checked my oil pressure I just kept moving forward. Any ideas on solving the rear bearing seal problem? Engine oil is cheap but I would like to fix it.

Thank you all for technical advice and helping in preparing the Plymouth your knowledge is priceless.

I would like to encourage all Plymouth owners to get out and experience what I have in the 16 days and 1900 miles itís worth it.

Enjoy :)

Rodney
Sydney, Australia  

3
General Discussion / Tasmanian Members
« on: March 29, 2009, 11:29:50 PM »
Hi all

I will be touring in Tasmania from the 13th July to 24th July 2009.

I was wondering if any members from Tasmania would be interested in catching up along the way.

The Vintage Motor Club, Sydney will have an assortment of ten or more different car makers built between 1919- 1930.

If anyone is interested let me know and I will forward you my travel plans?

Rodney, Sydney Australia

4
General Discussion / Radiator Gasket
« on: March 16, 2009, 03:38:45 AM »
Hi everyone

I need to replace the gasket between the head and the outlet flange on my 29U.
What type of gasket material do I use and any further tips with the procedure?
Hope all your cars will be ready for spring!

Drive Safe.

Many thanks

Rodney, Sydney Australia


5
General Discussion / 1929 article
« on: November 21, 2008, 05:34:08 PM »
Hi all

Found this article in a 1929 issue of The Saturday Evening Post. Enjoy the read!

Rodney
Sydney Australia

6
General Discussion / Decode my fedco No?
« on: November 08, 2008, 07:57:16 PM »
Hi all

Can anyone help me decode my fedco No?

RY-7OC

Its from a 29U roadster.

Sydney, Australia.


Many thanks

Rodney

7
General Discussion / New member from down OZ
« on: August 04, 2007, 12:22:43 AM »
Hi all

My name is Rodney from Sydney Australia and my wife and I have a 1929 roadster which I have owned for the past 21 years.
I am the second owner of this rare vintage car. I belong to a vintage car club and all the members have played a big part
in keeping this roadster on the road! Thanks for this forum.

Pages: [1]