gary
  How is the spring in the handle?  That is waht cause it most of the time.  Or you may need to take it apart and do some adjusting on the spring stop.  Good luck Craig

I got my sills in today and they are great!! I would recomend DON to any one thanks for the Input!!!!!! Thanks Craig

Hope this helps this is what my gase tank had on it the gage was missing but it had these parts that the glass and cover screwed on and it had gasket in and under everything.  I think that mine would use a modern typr gage with manual reading any that what i have found to use.  I haft to adapt one.  Good luck Craig

Thanks Gary

  I bill be sending mine to him so he can make thanks Craig

i am refering to the door sills at carpet or floor mat at edge of door at bottom, the aluminum pieces thanks Craig

My sill plates for the '29 4dr are real bad shape and have tried to use some ford ones and they are all to short does any one have any ideas were to get some or have some one that makes them thanks Craig

Chet


  Thanks that is what mine seem to measure just wanted to make sure thganks for the HELP!!!

Please some one let take one out and tell me what you have thanks Craig

I need a running board lenght for 29 ply.  I have a 4 dr sedan but think they are all the same.  If I can get 3 or more mesurements that would be nice.  The guy said to measure mine but the fenders are not on yet and the ones that came off were cobbled and need to give him time to get them done so i can put the car together when they come. Thanks Craig

 I have found a 28 coupe if interested look this guy up.  If some one buys it I would like to buy the column spark rods.  Good luck Craig   info is

1928 plymouth - parts for sale - I have been collecting this car in parts for many yrs and now have most of the major parts cept frame and engine block.  list includes: - 2 full rear quarters sets,  front spindle, all 4 brake drums, reaer housing, steering column and 2 wheels, original like new honeycomb rad, rad chrome x2, gullwing hood, firewall, piston rods, trunklid, doors and handles and winders too


my location is in Calgary Aberta Canada


email: Boshido_Auto_Rescue@live.com


phone:403-457-3811

Can any one please take a picture of their dash screws for me i need to buy some and dont know what they look like and know they are an odd size  thanks Craig

Does any one have the correct lenght for the 29 ply plug wires and coil wire.  Mine has been altered and the car is at the wood shop and want put this together thanks Craig

Sir

First of all If any one has a spare Chrome IGN. cover for a 29 I would like to buy it thanks Craig

   To get the Chrome metal off,  there should be four bent areas on the chrome that has been bent under the metal plate. Then you will be able to take the bezel off, then you will find two screws under the black plate and chrome that hold that metal plate on.  After you remove the plate that held the chrome bezel on then you can bend the tabs that hold the switch to the coil.  Ok as far as the decal you can buy on from Floyd Carlstrom, 3151 Country Trunk J, Vernona, WI 53593-9085 www.dashknobs.com 608 845 7855 (before 8pm est)  He will be gone for 6 weeks as of Sat the 31st of Jan I just got my decals in for the gages and they will work great for me.  I hope this helps and not to much rambling Good Luck Craig

Can someone tell me the size of the screws that are on the dash rail and may even have some that I can buy thanks craig

Does any one have info on dash rail screws for the 29 plymouth thanks Craig