Key lock handle is on the passenger side. (mine was and I believe it is correct based on past discussions)
NEW FORUM version is here.
If you are experiencing any problems, contact chetbrz@aol.com
WELCOME Auto Registration is turned OFF.
In order to register for this forum please contact chetbrz@aol.com to request access.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: rwollman on May 01, 2018, 07:45:08 AM
ON oil pressure with vacuum canister vs electric pump I have found that oil pressure is increased quite a bit with the deletion of the vacuum line.
I attribute this to fact that there is no oil aeration in pump caused by air. lifter noise, don"t think this is plausible as lifters are not hydraulic. Would sooner think there is a lifter to valve clearance problem once engine reaches operating temp.
Does anyone have a good way to set timing on these engines? I know it is set thru #3 cyl on exhaust stroke with a dial indicator at .050-.048 BTDC. gtotta be a better way.. Just my 2 cents on project.