• Welcome to 28Q29U Plymouth Forum.
 

News:

NEW FORUM version is here. 
If you are experiencing any problems, contact chetbrz@aol.com
WELCOME Auto Registration is turned OFF. 
In order to register for this forum please contact chetbrz@aol.com to request access.

Main Menu

Some dimensional help needed.

Started by chetbrz, February 10, 2017, 10:57:25 AM

Previous topic - Next topic

chetbrz

I have been working on a wood templet from which I will cut my new sill plates.  I have completed the template and I am now looking to confirm my work before cutting the hardwood for the Sills.  Since the Sill member is bolted to the frame in 7 places on both sides I am very confident that my measurements are dead on accurate.  As a quick check I was wondering if someone with a 29U 4 Door sedan could provide the following rear body section width measurement.

I am looking for a ballpark measurement as a check:  From the right bottom edge of the rear door support member steel cap, at the floor to the left side.  See pictures for clarity.  Both rear doors would have to be open so you can measure from outside edge to outside edge.

 

Many Thanks in Advance,  Chet...
http://www.1948Plymouth.info           Web Master - Forum Administrator - AACA member

29UJohn

Mine measures approx 52+5/8 inches.
John
1929U 4 Dr

chetbrz


Thanks John, I seem to be dead nuts at 52.5"

It looks like the templet is correct.  Will start on the actual sills today.  Weather permitting.

Thanks Chet...
http://www.1948Plymouth.info           Web Master - Forum Administrator - AACA member

chetbrz

Could use another check measurement Please:

The distance between the rear doors.  See picture below:



Many Thanks,  Chet...
http://www.1948Plymouth.info           Web Master - Forum Administrator - AACA member