• Welcome to 28Q29U Plymouth Forum.
 

News:

NEW FORUM version is here. 
If you are experiencing any problems, contact chetbrz@aol.com
WELCOME Auto Registration is turned OFF. 
In order to register for this forum please contact chetbrz@aol.com to request access.

Main Menu

Does Anyone know...

Started by chetbrz, December 02, 2017, 04:53:25 PM

Previous topic - Next topic

chetbrz

Does anyone know if the Bell Housing on a 29U engine can be removed without loosening or removing the flywheel.

http://www.1948Plymouth.info           Web Master - Forum Administrator - AACA member

sunnen1250

You need to remove the clutch release fork in order to remove the clutch cover and disk.  You then must remove the flywheel. You must support the engine block and remove the rear engine mount bolts and the fasteners holding the flywheel housing to the engine block.  With the block supported you may then remove the flywheel housing.

chetbrz

http://www.1948Plymouth.info           Web Master - Forum Administrator - AACA member