• Welcome to 28Q29U Plymouth Forum.
 

News:

NEW FORUM version is here. 
If you are experiencing any problems, contact chetbrz@aol.com
WELCOME Auto Registration is turned OFF. 
In order to register for this forum please contact chetbrz@aol.com to request access.

Main Menu

Side mount hardware

Started by Russ T. Fender, February 04, 2022, 10:05:51 AM

Previous topic - Next topic

Articifer Tom

Having any luck  , tracking down ?

Russ T. Fender

No luck so far.  I followed up your lead on the AACA forum with no results.  I have feelers out but no responses yet. While I am in no rush I expect I will eventually have to make something up.

Articifer Tom

I'll  measure mine up when you say .

Russ T. Fender

Thanks Tom.  Anytime you get to it would be fine.

Articifer Tom

Sorry for delay Russ here ;You cannot view this attachment.

Articifer Tom

Pics also ;You cannot view this attachment.

Articifer Tom

more;You cannot view this attachment.

Russ T. Fender

Wow Tom that is exactly what I needed.  Looks a bit more complicated than I thought but I'll give it a go. I really appreciate all the time you put into drafting that diagram! I have an aluminum block that I am going to use to make a pattern and if that works out I will have them cast in brass.

Articifer Tom

Your welcome .. I thought if you just wanted functional maybe fab from 1" channel or tube stock split . The dimple on end , leveler by hump where bolt goes up thur pushing down to the rims edge with that fork end , does it .