Glen !!
       Thank you
Under my hood is not as clean as yours !
Most new cans in Australia now come with plastic screw tops ! The search is still on.

Thank you vey much Glen its a great help !
It looks to be 3x5inch appox.

Thank you Glen !
                     I can assume it will be the same or similar , as I will need to hunt one down. Will appreciate picture Thank you.

One of our Vintage car members told me that the impeller is what stops fan going forward and will slowly wear down impeller ! He also said that he believes it should have oil caps instead of grease nipples because underneath rear bush there is a small reservoir with a wick that goes into it . It does make sense although I have not seen the inside as yet !!!

Hi All !
        I read that 30U should have 2 blade fan my car has a 4 blade , I'd rather 4 But dont know if this is original and I'm shore a 4 blade will put more wear on water pump impellor,any Idea's ?

Any further news on Balancing Gary ?

Hi All  !!
     I bought my hoses from ebay CA. for 30u Are on car now work fine think I paid around $ 21 USD

Hi all !!
        Would anyone have a picture of a brake master cylinder reservoir that goes on firewall of 30U ?
Thanks Tony.

Hi Guys !!
             I have worked on quite a few engine rebuilds and tend to agree 100% with Rusty !
When my engine gets pulled down in future will be getting full rotating assembly balance. (Its not a smooth engine)

Thank you Craig !
                      When you come across it are you able to take a picture of it Thanks Tony.

Thank you Doug and Gary !!
Looks like windscreen attaches  to outer wheels at each end of mechanizm, and there should be a sliding channel attached to top of glass ? At least now I know what to look for.

Thank you guys !!
everyone is so helpfull , I really appreciate  the effort you all put in !

Would anyone have a picture of winder mechanism for windscreen ?
Thank you Tony

Hi Gary !!
           What the others are saying about distributer slop sounds correct not really  worth worrying over, Vibration issue sounds like whole rotating assembly of engine may require balancing including clutch and pressure plate , My 30U engine has the exact same conditions .

My 30u has a cam lever on each rim had to repair 1 lever today as I just purchased 5 new tyres, getting old tyre of the rim was not to hard ! Getting rim of the car  was another matter ,tying to seperate wood spoke rim from tyre rim (must be an easer way )
Must be a technique to it !!