Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mopardave

Pages: [1] 2 3 ... 6
1
General Discussion / Re: Distance Driving
« on: December 16, 2012, 01:31:21 PM »
I put about 150 miles a year on my "Q", but it is all short hops.

2
General Discussion / Re: Comfortable Crusing Speed of Your Plymouth
« on: November 16, 2012, 08:05:18 PM »
My Q seems pretty comfotable around 35 mph

3
General Discussion / Re: Battery Tenders - Any comments or recommendations?
« on: November 03, 2012, 08:19:16 PM »
I have Battery Tenders for all my cars, both 6 and 12 volt.  Used them for years with no issues.

4
General Discussion / Re: Forgive my ignorance re brake fluid
« on: May 19, 2012, 09:58:12 AM »
I went the silicon route for a while, but I had problems with it so I am back to good old DOT 3 and just rebuilding every 5-8 years.

5
General Discussion / Re: Running Board Aluminum Trim Finish
« on: August 13, 2011, 08:12:57 AM »
The trim on my "Q" is unfinished.  The car was restored in the 60's and I have no way of knowing if it is correct or not.

6
General Discussion / Re: Tools
« on: July 22, 2011, 11:14:03 AM »
Sure, I can do that.  They are in a toolbox mounted on the driver's running board.  I wrap them individually so they don't rattle.  you can e-mail me at mopardave@aol.com


7
General Discussion / Re: Tools
« on: July 21, 2011, 06:48:38 PM »
These are the tools that came with my car:




8
General Discussion / Re: Tools
« on: June 20, 2011, 11:22:22 AM »
I have a couple of the tools that came with my '28.  Certainly not the whole list.  I will have to dig them out and see what is there.

9
General Discussion / Re: Taken 30U for a drive just made it back!!
« on: May 06, 2011, 07:51:58 AM »
Been there, done that.  Rear brake line also.  It's a good thing they aren't fast cars!

10
General Discussion / Re: Interior Light '29 Ply I.D. ?
« on: April 12, 2011, 04:09:53 PM »
That looks like the light in my '28.  I can't get a pic until I get the car out....if it ever stops raining!

11
General Discussion / Re: Pin Striping the 1929 Plymouth Coupe
« on: April 10, 2011, 07:45:29 AM »
Thanks Gary, but I don't think I will change it now.  I am thinking about selling the car and someone asked me.

12
General Discussion / Re: Pin Striping the 1929 Plymouth Coupe
« on: April 09, 2011, 04:55:44 PM »
While we are on the subject of wheels, can anybody tell me if the natural finish wheels on my cat are correct?  They were finished that way during the restoration in 1975.

13
General Discussion / Re: Pin Striping the 1929 Plymouth Coupe
« on: April 03, 2011, 11:30:07 AM »
that picture was taken last summer, Glenn.  Yesterday's snow is just about all gone today.

14
General Discussion / Re: Pin Striping the 1929 Plymouth Coupe
« on: April 03, 2011, 09:55:30 AM »

15
General Discussion / Re: Pin Striping the 1929 Plymouth Coupe
« on: April 03, 2011, 09:04:48 AM »
The width of the stripe on my car is 1/16 inch.

Pages: [1] 2 3 ... 6