Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kimmc

Pages: 1 ... 12 13 [14]
196
General Discussion / steering gear control cover
« on: February 20, 2010, 03:40:27 AM »
Can someone tell me how to remove the "steering gear control cover", that donut shaped bakelite piece that surrounds the horn button and covers the light and throttle levers on the steering wheel of my '29 coupe.  I want to start working on fabricating new levers as my pot-metal ones are broken (as most are I understand).  It seems like it should unscrew but I can't budge it and I don't want to break it.  I thought someone out there might be able to give me some advice.  Thanks.  Kim Mc

197
General Discussion / Re: '29 ignition switch/coil combo...
« on: February 05, 2010, 05:50:24 PM »
Hey, thank you Craig!  I thought the bent under corners on the chrome bezel were just damage from a prior attempt to bend the tabs holding the switch to the coil.  Your instruction and info re the decal have been a tremendous help.  Because of the age of the coil, the poor condition of the pot metal switch, and that the ignition key has been lost, I presumed I should just start with a new coil and ignition like that offered by Atwater Kent (link below).  Do you agree?  Do you know if my old mounting bracket on the coil comes off and should be used to mount a replacement coil (this is probably a question for Atwater Kent).  Send me a picture of your '29 if you have time.  Thanks again for your reply...you've been a great help.  Kim Mc

http://atwaterkentmfg.com/Ignition%20Coils.htm#4

198
General Discussion / '29 ignition switch/coil combo...
« on: February 05, 2010, 02:55:53 AM »
I just removed the combination ignition switch/coil from my '29 coupe.  The switch on the back of the coil is pot metal and has so many cracks in it that it could crumble in many small pieces at any time (picture attached).  I'm sure these are the original parts.  I was planning to replace this with a new switch/coil combo from Atwater-Kent.  Does someone know how the bezel surrounding the lock cylinder is attached and how to remove it without damage?  Has anyone installed the Atwater-Kent switch/coil combo?  Also, is there anyone out there that refurbishes the bezel with new paint, lettering (ignition,on, off, lock).  I don't know if the coil is good and the key has been lost.  Any advice or guidance you might be able to provide is appreciated.  I am a novice at this.  Thanks.  Kim Mc

Pages: 1 ... 12 13 [14]