Author Topic: Manufacturers plate  (Read 37 times)

Russ T. Fender

  • Senior Forum Member
  • ****
  • Posts: 189
    • View Profile
Manufacturers plate
« on: April 07, 2021, 05:08:28 PM »
Is this plate mounted on the inside of the firewall? It has been off the car so long that I don't remember where it goes.

chetbrz

  • POC MEMBER
  • Senior Forum Member
  • ****
  • Posts: 1912
    • View Profile
    • My Space on the Web
Re: Manufacturers plate
« Reply #1 on: April 07, 2021, 07:22:50 PM »

Yes it attaches to the two small holes on the firewall near the Vacuum fuel pump.

http://www.1948Plymouth.info           Web Master - Forum Administrator - AACA member

Russ T. Fender

  • Senior Forum Member
  • ****
  • Posts: 189
    • View Profile
Re: Manufacturers plate
« Reply #2 on: April 08, 2021, 07:38:40 AM »
Thanks Chet.  What threw me is that those holes have been closed up with primer and paint.  The picture is just what I needed!

chetbrz

  • POC MEMBER
  • Senior Forum Member
  • ****
  • Posts: 1912
    • View Profile
    • My Space on the Web
Re: Manufacturers plate
« Reply #3 on: April 09, 2021, 09:11:40 AM »
How is your project coming.  Have you fired up the engine yet ?  Myself I havenít done anything with cars lately just taking a needed break.
http://www.1948Plymouth.info           Web Master - Forum Administrator - AACA member

Russ T. Fender

  • Senior Forum Member
  • ****
  • Posts: 189
    • View Profile
Re: Manufacturers plate
« Reply #4 on: April 09, 2021, 11:13:24 AM »
I have not started the engine up yet as I decided to wait and get the body back from the painter and set it on the chassis first.  Unfortunately, I need the assistance  of a few strong helpers to do that and since all of my friends are either my age or older it is proving to be a bit difficult to line up the manpower.  I have done it before myself but now that the painting is done I don't want to mess that up. 

Russ T. Fender

  • Senior Forum Member
  • ****
  • Posts: 189
    • View Profile
Re: Manufacturers plate
« Reply #5 on: April 09, 2021, 11:22:45 AM »
I tried to post a picture of where I am now but for some reason when I hit "attachments and other options" nothing happens.  I will try again later.

Russ T. Fender

  • Senior Forum Member
  • ****
  • Posts: 189
    • View Profile
Re: Manufacturers plate
« Reply #6 on: April 09, 2021, 01:06:21 PM »
Try again